The handlebar has at least one drilled or milled out hole in which the headlight lens is integrated. Depending on the version, there may be an additional hole for the power supply. In addition, the headlight (LED, lens and circuit board) is built into the handlebar in such a way that it is protected from the elements. The handlebar is sealed so that water cannot enter.
Center 31.8㎜ / Grip 22.2㎜
620 / 640 / 700㎜
Flat, Back sweep 9˚, Up sweep 0˚, Rise ±5㎜
and surface finish
Polished / Anodized / Painted
Aluminum 6061 T6
An LED with integrated electronic light control. The lens itself does not have a reflector and is protected by an additional protective screen.
The LED, circuit board and battery are fully integrated in the handlebar tube and are thus protected (dust and splash proof in accordance with IPX4).
LightSKIN H2 Lens
Lithium-polymer battery 3.7V, 2000mAh, 8018120 with protection
(fully charged battery)
Extra bright: 4h
ISO 4210 Mountain
standard or directive
RoHS, UN3481, StVZO §22a TA Nr.23
(Headlights for bicycles), IPX4
Front light handlebar
USB charge cable (200cm)
The handlebars must be mounted centrally in the stem and the headlight must not, under any circumstances, be covered.
The headlight must be mounted so that it emits light from the front. The reference axis (see drawing) must be aligned parallel to the bicycle’s longitudinal axis.
Mounting height of the headlight
according to the StVZO
The headlight is operated by a button on the front side of the handlebar.
Off→ On(extra bright)→On(bright)→Off
Low battery alert
Indicated by a blue LED integrated into the micro-USB socket.
As soon as this LED lights up, the battery still has enough capacity to power the LEDs for 1 more hour in accordance with the regulation. The micro-USB port is covered with a semi-transparent silicone cap so that the blue LED is visible and the port protected from the elements.
Micro USB 2.0 charging
In order to reach the full load capacity, it takes between 4 and 5 hours. During charging, the button cap flashes in RED. The flashing stops, changes to continuous red light on when the battery is completely charged. When the battery is fully charged, remove the cable from the USB port. Should the product become excessively hot during charging, stop the charging process. Never charge the battery when the USB port is wet. Full charge and discharge cycles 500.
Steps to take in
the event of a failure
If the headlight fails, it must be immediately replaced.
Do not pull on the charging cable excessively.
If the USB connector is exposed to heat, it may lose its shape.
We recommend using the supplied USB cable to ensure proper battery charging.
Min: -15° C
Max: 45° C
Optimum storage temperature: 20-25°C
Please send us unused products by prepaid, will refund you after confirming arrival.
Please send us unused items by prepaid, and send $25~$35 re-delivery courier fee depending on your location.
After receipt the goods and courier fee, we will replace it with another product.
Seatpost and light module: 2 years from the date of purchase.
In case of warranty, (replacement or repair), please contact the distributor through whom the product was purchased.
The product packaging is made of recyclable materials.
Dispose of these environmentally friendly in the provided collection containers.
Old appliances and batteries must not be disposed of with normal household waste.
According to EU Directive 2012/19/EU, the product must be disposed of properly at the end of its service life.
Return the old device to a collection point for electronic waste or a recycling center.